Scoreboard 3050 Manual: Mounting Hardware

MOUNTING HARDWARE

Four sets of mounting hardware are provided to attach the model 3050 at these points.  A single set of mounting hardware for the unit consists of a steel angle bracket, two threaded rods, two washers, and two nuts.  Figure 4 shows an overhead cross section view and a side cross section view of the model 3050 attached to a post at a mounting point.  A steel bar is riveted inside the product’s aluminum extrusion frame.  The bar has two tapped holes.  The threaded rods screw into these tapped holes.  The washers and nuts are used to clamp the steel angle bracket against the steel post and hold the unit in place.

Figure 4  Standard Mounting Method

The following steps describe how to mount the model 3050 on the posts:

1. Make sure the mounting points are aligned with the posts.
   1. Screw the threaded rods into the tapped holes in the cabinet.
   2. Place a steel angle bracket over the threaded rods at mounting point #1.
   3. Place a washer over each threaded rod.
   4. Screw the nuts onto the threaded rods so that the bracket is loosely held in place.
   5. Repeat steps 3 - 6 at the other mounting points.
   6. Raise the cabinet into place and tighten the nuts to clamp the cabinet in place on the posts.