INSTALLATION

This part of the manual describes the mechanical and electrical installation of the product.

One of the items listed below must be purchased in order to complete the installation:

• Control cable (length dependent upon installation site layout)
• ScoreLink 300 RF Modem System

Items not provided by Electro-Mech Scoreboard Company that are necessary for installation:

• Four posts (two for each unit)
• Power cables to connect each unit to the power source
• Grounding hardware
• A grounded NEMA 5-15R 120 VAC receptacle for the control console at the scorekeeper’s table.

Items not provided that are recommended by Electro-Mech Scoreboard Company for installation:

• A weatherproof power disconnect at each unit

Electro-Mech Scoreboard Company performs installations in some areas.  In other areas, we can help you contact an independent installer.  In areas in which installation service is not available from Electro-Mech Scoreboard Company, we will make every effort to answer your installation questions.  Qualified personnel should perform the product installation.  Consult national and local codes before installation.