SCOREBOARD INSTALLATION

This part of the manual describes the mechanical and electrical installation of the scoreboard.  Figure 1 shows a typical installation of the scoreboard in a gym.

Figure 1  Typical Installation

One of the items listed below must be purchased in order to complete the installation:

• Control cable (length dependent upon installation site layout, but not to exceed 1000 feet between a console and the scoreboard)
• ScoreLink 200 RF Modem System (3 sets required on separate channels)

Items not provided by Electro-Mech Scoreboard Company that are necessary for installation:

• Wall fasteners
  • Grounded NEMA 5-15R 120 VAC receptacles for the 3 control consoles at the scorekeeper’s table.

Electro-Mech Scoreboard Company performs installations in some areas.  In other areas, we can help you contact an independent installer.  In areas in which installation service is not available from Electro-Mech Scoreboard Company, we will make every effort to answer your installation questions.  Qualified personnel should perform the scoreboard installation.  Consult national and local codes before installation.