SHOT TIMER INSTALLATION

This part of the manual describes the mechanical and electrical installation of the shot timer.

One of the items listed below must be purchased in order to complete the installation:

• Control cable (length dependent upon installation site layout)
• ScoreLink 200 RF Modem System (a transmitter and two receivers)

Items not provided by Electro-Mech Scoreboard Company that are necessary for installation:

• Hardware to attach the shot timer to the wall or basketball goal.
• A grounded NEMA 5-15R 120 VAC receptacle for the control console at the scorekeeper’s table.

Electro-Mech Scoreboard Company performs installations in some areas.  In other areas, we can help you contact an independent installer.  In areas in which installation service is not available from Electro-Mech Scoreboard Company, we will make every effort to answer your installation questions.  Qualified personnel should perform the shot timer installation.  Consult national and local codes before installation.