INSTALLATION

This part of the manual describes the mechanical and electrical installation of the model 2055 player statistics panels.  Figure 1 shows a typical installation in a gym.

Figure 1  Typical Installation

A typical installation consists of a set of two model 2055 player statistics panels installed on a wall around a basketball scoreboard, as seen in figure 1.  Since the model 2055 player statistics panels operate independently of the basketball scoreboard, it is not mandatory to install them in this manner.  One of the items listed below must be purchased in order to complete the installation of the model 2055 player statistics panels:

• Control cable (length dependent upon installation site layout, but not to exceed 1000 feet between a console and a player statistics panel)
• SL-230 / 330 RF Modem System

Items not provided by Electro-Mech Scoreboard Company that are necessary for installation:

• Wall fasteners
  • Grounded NEMA 5-15R 120 VAC receptacles for the 2 control consoles at the scorekeeper’s table.

Installation requirements for the basketball scoreboard are described in the owner’s manual for that product.  Electro-Mech Scoreboard Company performs installations in some areas.  In other areas, we can help you contact an independent installer.  In areas in which installation service is not available from Electro-Mech Scoreboard Company, we will make every effort to answer your installation questions.  Qualified personnel should perform the scoreboard installation.  Consult national and local codes before installation.