Scoreboard 1250 Manual: Mounting Hardware

MOUNTING HARDWARE

Four sets of mounting hardware are provided to attach the scoreboard to the posts.  Additional hardware sets are provided to attach the optional sponsor panels, if ordered.  A mounting hardware set consists of a steel angle bracket, two threaded rods, two washers, and two nuts.  Figure 6 shows an overhead cross section view and a side cross section view of the scoreboard attached to a post at a mounting point using the hardware.  A steel bracket is riveted to the scoreboard’s aluminum extrusion frame.  The bracket has two tapped holes.  The threaded rods screw into these tapped holes.  The washers and nuts are used to clamp the steel angle bracket against the steel post and hold the scoreboard in place.

Figure 6  Standard Mounting Method

The following steps describe how to mount the scoreboard on the posts:

1. Make sure the mounting points are aligned with the posts.
   1. Screw the threaded rods into the tapped holes in the scoreboard.
   2. Place a steel angle bracket over the threaded rods at mounting point #1.
   3. Place a washer over each threaded rod.
   4. Screw the nuts onto the threaded rods so that the bracket is loosely held in place.
   5. Repeat steps 3 - 6 at the other mounting points.
   6. Raise the scoreboard into place and tighten the nuts to clamp the scoreboard in place on the posts.

Note:  Be sure to leave enough space on the posts above the scoreboard for the optional top sponsor panel, if purchased.

Mounting The Optional Top Sponsor Panel

The following steps describe how to mount the top sponsor panel on the posts:

1. Make sure the mounting points are aligned with the posts.
2. Screw the threaded rods into the tapped holes in the top sponsor panel.
   1. Place a steel angle bracket over the threaded rods at a mounting point.
   2. Place a washer over each threaded rod.
   3. Screw a nut onto each threaded rod so that the bracket is loosely held in place.
   4. Repeat steps 3 - 5 at the other mounting points.
   5. Tighten the nuts to clamp it in place on the posts.